Laboratory exhaust and ductwork being balanced during a VAV and CAV air balancing job in Alberta
Home/Decommissioning & Air Balancing/VAV & CAV Air Balancing
Decommissioning & Air Balancing

VAV & CAV Mechanical Air Balancing

Every fume hood shares the building's air. Change one thing and the pressure shifts for the whole room. We balance VAV and CAV systems and sync the exhaust fans so each hood still pulls the way it should.

A fume hood is only as good as the air feeding it. When a hood is added, removed, or a duct gets rerouted, the pressure across the room changes, and a hood that used to contain can start pushing fumes back at the worker. Air balancing is how we set it right again.

Technician working on large ductwork for VAV and CAV air balancing

Air balancing tunes the exhaust and makeup air across a lab so every hood, room, and duct gets the airflow it is supposed to. We work with both CAV systems, where the exhaust is constant, and VAV systems, where the airflow changes with the sash or a sensor to save energy.

VAV and CAV, and why they balance differently

  • CAV (constant air volume): the exhaust runs the same all the time. Simpler, but every change ripples through the room.
  • VAV (variable air volume): airflow rises and falls with the sash or a sensor. It saves energy but needs careful setup so a closed sash still keeps a safe minimum.
The trap with VAV: if the minimum airflow is set too low, a hood with the sash down can stop containing. We set the minimum and maximum so the hood is safe at every sash position.

What we do

Pressure balancing

We set the room pressures so air flows the right direction, from clean spaces toward the hoods and out, not the other way.

Exhaust fan synchronization

When several hoods share exhaust fans, we sync them so the system stays stable as loads change, instead of fighting each other.

Confirm containment

We finish by confirming each hood holds its face velocity, so balancing the room did not starve a hood.

When you need balancing

After a hood is added or removed, after decommissioning, after HVAC work, or when hoods fail their certification for reasons that trace back to the room. Once balanced, we can calibrate the airflow monitors to match.

Good Questions

Frequently asked questions

CAV keeps the exhaust airflow constant at all times. VAV changes the airflow based on the sash position or a sensor, which saves energy. They are set up and balanced differently, and we work with both, including the exhaust fan controls.

Renovations change the building's airflow. Adding or removing hoods, or rerouting ducts, shifts the pressure across the room, so a hood that passed before can fail after. Rebalancing the room usually brings it back into range.

When several hoods share exhaust fans, the fans need to work together as loads change. If they are not synced, they can fight each other and make airflow unstable. We tune them so the system stays steady.

Always. Balancing a room can starve a hood if it is done carelessly, so we finish by checking each hood's face velocity to confirm it still contains. We do not call the job done until it does.

Not sure where to start? Just ask.

Describe what is in your lab and we will tell you what testing or cleanup makes sense, with no obligation.

Book a Site Assessment